close
close

How To Replace Honeywell Thermostat On Water Heater

How To Replace Honeywell Thermostat On Water Heater. Slide it down so it catches the grooves (or screws) on the wall plate to sit in place. Replace each thermostat by sliding it evenly downward into the holding bracket until it locks in place.

How to Replace a Heating and Cooling Thermostat eHow
How to Replace a Heating and Cooling Thermostat eHow from www.ehow.com

Smith, or some other brand of hot water heater. Now, press the “up” arrow button for some time without losing the “fan” button. Press and hold down the menu button for 5 seconds.

The Wt8840 Series Is The Water Heater Control For Trade Use To Replace Wv8840 Valves Used In Aosmith And Bradford White Water Heaters.

Locate the batteries by removing the battery compartment tray or cover or by removing the unit’s faceplate. I have a new programmable honeywell t4, th4110u2005 thermostat that was programmed by an installer so that the set temperature will always stay at the set temperature all year round. Press and hold down the menu button for 5 seconds.

Honeywell Wt8840A1500 Gas Valve, White

All honeywell thermostats that have batteries store the batteries in the control panel. If you see the pilot is being lit, then you have cold water in the tank. Disconnect the gas line and thermocouple from the front of the water heater at the thermostat using a pipe wrench.

Restore Power And Allow The Water Heater To Work For One Hour Before Testing The Hot Water.

Carefully extract the batteries, and replace them. Replace each thermostat by sliding it evenly downward into the holding bracket until it locks in place. You can open up both the old and replacement valve, and just swap the frontsof the valves, containing the recalcitrant circuit board, leaving the back part that connects to the gas pipes in place.

Its 17 Degrees Outside, The Thermostat Is Set To Heat A.

It is designed for use in standing pilot applications using an immersion well for water temperature sensing. If it is accompanied by the burner being off and yet the thermostat is up, it can be either the gas valve (of the water heater) is bad or you have a clogged burner orifice. Place the thermostat flush against the wall, slightly above the wall plate.

Here Are Some Quick Tips On Resetting The Factory Setting To Most Honeywell Thermostats:

To find out which pair is defective, turn on a hot water faucet. Water heater regulator valve gas control ionizer honeywell. Before you suspect a malfunctioning heating element, you should first test the thermostat.

Leave a Reply