How To Disconnect Water Line From Whirlpool Fridge. Clamp onto the nut on the freezer pipe with a pair of small pliers. If the valve is hidden in a box covered by a plastic or metal guard, unscrew the guard to reveal the valve.
Here are a few tips to help with how to properly disconnect a water line for an icemaker: Throw out the water once the line stops dripping. If you can’t conveniently reach the power plug, then turn off the breaker in your kitchen.
Unplug Refrigerator Or Disconnect Power.
Find the water supply valve and shut it off. Turn the water supply valve where the refrigerator line connects all the way to the right. In the cabinet next to the refrigerator.
There Will Be Some Water Left In The Lines.
If it does, it's likely there was an air clog in the line which should now be removed. Find a ¹⁄₂ to 1¹⁄₄ (12.7 mm to 31.8 mm) vertical cold water pipe near the refrigerator. Find the water dispenser line and unscrew the screws holding it in place.
I Would Make Sure The Water Supply Was Off Before I Did This, Though Why Do You Need To Remove These Two Lines?
If the ice maker fill tube is frozen inside the freezer where it goes into the ice maker, it will spray from there. Remove the ice bin and dump the ice out in the sink. How do you disconnect the water line on a whirlpool refrigerator?
In A Typical Kitchen Setup, The Refrigerator Water Line Is Tied Into The Cold Water Line Beneath The Kitchen Sink.
To be sure, refer to the user manual or technical sheet to identify and locate the inlet. Normally, the easiest way to do this is to pull the power plug. Connect to water line 1.
Remove The Toe Kick Grille At The Bottom Of The Refrigerator By Grasping It With Your Hands And Pulling It Toward You.
Clamp onto the nut on the freezer pipe with a pair of small pliers. Move the refrigerator forward to reveal the location of the valve. Close the water line to the fridge