close
close

How To Connect Galvanized Pipe Without Threads To Pex

How To Connect Galvanized Pipe Without Threads To Pex. To eliminate rust issues, use a stainless steel coupler. A coupler joins two pieces of unthreaded galvanized tubing.

Plumbing With PEX Tubing The Family Handyman
Plumbing With PEX Tubing The Family Handyman from www.familyhandyman.com

To connect unthreaded galvanized piping, you will need to use a coupling to place the two pipes together. About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features press copyright contact us creators. Set the coupling end with the drawn line on the pipe with an aligned mode.

At The Last Point, You Need To Tighten The Fastening Bolts Until The Coupling Gets The Galvanized Pipes In The Right Place.

I will post in another video why you should not use a self. Set the coupling end with the drawn line on the pipe with an aligned mode. You could transition to a 3/4 galvanized or brass nipple with the threads cutoff one end.

A Dresser Coupling Will Compress Around A 3/4 Galvanized Line.

To eliminate rust issues, use a stainless steel coupler. This may be a regional or colloquial term but probably evolved from a manufacturer's name. Depending on the type of pex fittings used, a dielectric union might be needed.

These Are Designed For Pressure Pipe, The Size Designed For 1/2 Galvanized Pipe Also Fits 3/4 Copper.

These are not designed to be installed in locations where a leak would not be evident/fixable, and they do. How do you connect galvanized pipes without threads to pex? A coupler joins two pieces of unthreaded galvanized tubing.

They Make Fittings That We Call Moody Couplings;

About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features press copyright contact us creators. Install a threaded transition fitting to go from galvanized pipe/fitting to pex tubing. About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features press copyright contact us creators.

My Preference Is To Connect That Brass Pex Fitting To The Threaded Galvanized Pipe After Removing The Elbow, But If I Run Into Problems Or Damage The Threads Or Whatever, My Backup Solution Is To Cut The Galvanized And Use A (Galvanized) Connector (As In Photo) To Connect To The Pex.

Then use a flare adapter to go to copper, or use whatever adapter you would use to go to whatever material you would want. Once you have selected the correct coupling, you will need to use fastening bolts and a torque wrench to keep the two pipes coupled. Replace or repair a galvanized pipe to pex because of a leaking and rotten piercing saddle valve.

Leave a Reply