close
close

How To Change Code On Schlage Lock Without Programming Code

How To Change Code On Schlage Lock Without Programming Code. Especially if you create multiple access codes, you might need a way to remember what code belongs to whom. Schlage locks are great security devices for homeowners, but it’s important to know how to properly reset them.

[Guide] Schlage locks How to change the lock code
[Guide] Schlage locks How to change the lock code from keysmiths.com

So first how to reset schlage keypad lock? Follow the steps below to program new user codes on your schlage keypad lock: Wait for the schlage button to beep and flash three times.

Press The Schlage Button And The Number 1 Button Simultaneously.

Wait for the “schlage” button to beep and flash three times. To add a new entry code: The first step would be reprogramming the code for the lock.

Lost Or Need To Locate Programming Code And Serial Number.

Wait for the schlage button to beep and flash three times. The lock will flash green and beep once, and that means the operation is successful. Especially if you create multiple access codes, you might need a way to remember what code belongs to whom.

Press And Release The Schlage Button.

Track your codes the smart way. So first how to reset schlage keypad lock? Ensure your door is open as you’ll need to access the interior and exterior assembly of the lock at the same time.

Next, Press 3, Then Enter A New Programming Code (6 Digits) Twice.

To check that the lock was reset, press the outside schlage button and enter one of the default. How to reset a schlage keypad lock (without programming code) step 1: Press the “schlage” button and the number “1” button simultaneously to add/change a new entry code.

After That, Press Number 6, Then Enter Your Programming Code Again As A Confirmation Of The Removal Of All Of The Codes.

Homeowners that haven’t changed the original code should find it written in their installation guide or on the back side of the deadbolt. To add a new code at any time you will follow this sequence: Changing the access code length will delete all existing access codes!

Leave a Reply